Yamaha 006IPTO-F0 - Manual (Page 172)

172
Chapter 14—Scene Memories
DM1000 Version 2—Owner’s Manual
2 Use the cursor buttons, [SEL] buttons, or Parameter wheel to select the chan-
nel category, then use the [ENTER] button or the INC/DEC buttons to select
the copy source channel.
The number of the source channel is highlighted.
You can also select Group Masters, internal Effects, a User Defined Remote layer, or HA
(AD8HR/AD824) as copy sources.
3 Use the cursor buttons or Parameter wheel to select the copy source param-
eter, then press the [ENTER] button.
4 Press the DISPLAY ACCESS [SCENE] button repeatedly until the Paste DST
page appears.
5 Use the Parameter wheel or INC/DEC buttons to select the destination
scene(s).
Scenes specified between FROM and TO (inclusive) become the paste destination. You can
paste up to 10 scenes at a time.
6 Use the cursor buttons to select the PASTE button, then use the [ENTER] but-
ton to paste the settings.
You cannot paste the settings to write-protected scenes.
To restore the previous settings that existed before the paste operation, click the UNDO
button, then press [Enter]. However, if the settings in the scene are changed after the paste
operation (such as by saving, clearing, or sorting the scene, or receiving scene data via MIDI
Bulk Dump), the UNDO function is disabled. Also, note that you will not be able to undo
the operation after you turn off the power to the console.