Yamaha 006IPTO-F0 - Manual (Page 123)

Using the Talkback Function
123
DM1000 Version 2—Owner’s Manual
Control Room Monitoring
10
B CONTROL ROOM DIMMER LEVEL
This parameter determines the amount of attenuation applied to the Control Room
Monitor signal by the Dimmer function when you press the MONITOR [DIMMER]
button. The amount of attenuation can range from 0 dB to –96 dB.
C MONO
This button switches the Control Room Monitor signal into mono.
D MIX C-R SOURCES
Check this check box to select the [2TR D1] or [2TR D2] button and the [STEREO] but-
ton as the monitoring signal sources simultaneously.
3 Set the Control Room Monitor parameters as necessary.
4 Press the MONITOR [STEREO], [2TR D1], or [2TR D2] button to select the
monitoring signal source.
Each button selects the following monitoring signal sources. When the MIX C-R SOURCES
check box is checked, you can select the [2TR D1] or [2TR D2] button and the [STEREO]
button simultaneously. However, you cannot select both [2TR D1] button and [2TR D2]
button. If the MIX C-R SOURCES check box is not checked, you can select only one signal
source.
• [STEREO] button ........Selects the Stereo Out signal.
• [2TR D1] button ..........Selects the 2TR IN DIGITAL1 signal.
• [2TR D2] button ..........Selects the 2TR IN DIGITAL2 signal.
5 Adjust the monitoring level using the MONITOR [MONITOR LEVEL] control
while playing the sound sources.
To adjust the level of the monitoring signal via headphones, turn the [PHONE LEVEL] con-
trol.
Using the Talkback Function
The DM1000 features a built-in talkback microphone on the control surface. The Talkback
function distributes the Talkback mic signal to the specified outputs or slot channels. The
Talkback function is useful when you wish to communicate with the musicians in the studio
or record your comments to a recorder.
Note: In this case, the [2TR D1] and [2TR D2] buttons are effective only when external devices
are connected to the 2TR Digital Outputs respectively and are turned on.
Tip: If you change the 2TR DIN FLIP parameter setting, pressing the [2TR D1] or [2TR D2]
button enables you to monitor the OMNI IN signal, instead of the 2TR IN DIGITAL signal.
MONITOR
LEVEL
SOLO CLEAR
2TR D1 2TR D2
DIMMER TALKBACK
MONITOR
STEREO
SLOT BUS
DISPLAY
10 0