Yamaha 006IPTO-F0 - Manual (Page 220)

220
Chapter 17—Remote Control
DM1000 Version 2—Owner’s Manual
Display
While the Pro Tools layer is selected, you can use the [F2]–[F4] buttons as well as the left
and right [
]/[ ] Tab Scroll buttons to select display modes. You can select the follow-
ing display modes using these buttons:
■ Insert Display mode ( [F2] button)
Press the [F2] button to select Insert Display mode. In this mode, you can assign and edit
plug-ins.
A TARGET
This parameter enables you to select the remote control target device.
B COUNTER
This counter indicates the current position. This counter works in unison with the time-
code counter on Pro Tools. The display format of the counter is specified in Pro Tools.
The following three check boxes in the COUNTER section indicate the cur-
rently-selected format.
• TIME CODE:................ Pro Tools timecode format is set to “Time Code.”
• FEET: ............................. Pro Tools timecode format is set to “Feet:Frames.”
• BEATS:........................... Pro Tools timecode format is set to “Bars:Beats.”
• If no check boxes are selected:...........Pro Tools timecode format is set to “Min-
utes:Seconds” or “Samples.”
C SELECT ASSIGN
This parameter indicates the current function of the Encoders. For example, Pan, PanR,
SndA, SndB, SndC, SndD, or SndE (see page 222).
D P.WHEEL MODE
This parameter indicates the function currently assigned to the Parameter wheel (see
page 224).
3
4
5 2
1