Yamaha 006IPTO-F0 - Manual (Page 24)

24
Chapter 2—Control Surface & Rear Panel
DM1000 Version 2—Owner’s Manual
MONITOR Section
A [DISPLAY] button
This button displays a Monitor page, enabling you to adjust monitor settings (see page 119
and 136).
B [SOLO] indicator
This indicator flashes when a single or multiple channels are soloed.
C [CLEAR] button
This button “unsolos” all soloed Channels.
D [2TR D1] button
E [2TR D2] button
F [STEREO] button
These buttons select the Control Room Monitor output signal. When the [2TR D1] button
indicator is lit, the signal at the 2TR OUT DIGITAL 1 jack is selected. When the [2TR D2]
button indicator is lit, the signal at the 2TR OUT DIGITAL 2 jack is selected. When the
[STEREO] button indicator is lit, the Stereo Bus signal is selected.
If you change the parameter setting on the Monitor | C-R/TB page (see page 122), you can
monitor the OMNI IN signal, instead of the 2TR IN DIGITAL signal, when you press the
[2TR D1] or [2TR D2] button.
G [SLOT] button
H [BUS] button
These buttons select the Surround Monitor signal source. When the [BUS] button indicator
is lit, the Bus 1–8 signals are selected. When the [SLOT] button indicator is lit, the signals
from Slots 1/2 are selected. (See page 136 for more information on the Surround Monitor.)
I [DIMMER] button
This button activates the Dimmer function, which lowers the Monitor and Surround Mon-
itor signals. This function is convenient when you wish to talk in the control room during
mixdown. The [TALKBACK] button indicator flashes while the Talkback function is active
(see page 120).
J [TALKBACK] button
This button turns on the Talkback function. While the button indicator is lit, the Talkback
mic signal is sent to any desired Bus or Slot (see page 123).
K MONITOR LEVEL control
This control adjusts the monitor level.
Note:
• The DM1000 allows you to patch source signals to any output jack (other than the PHONES
jack). Therefore, the console does not feature a dedicated monitor output jack. Instead, you
can route monitoring signals to any desired output jack (typically to OMNI OUT jacks
1–12).
• By default, monitoring signals are assigned to OMNI OUT jacks 11 and 12.
MONITOR
LEVEL
SOLO CLEAR
2TR D1 2TR D2
DIMMER TALKBACK
MONITOR
STEREO
SLOT BUS
DISPLAY
10 0
9 J K
1
2
7
4
3
8
6
5