Yamaha 006IPTO-F0 - Manual (Page 37)

Assigning Parameters to the ENCODER MODE [ASSIGN] button
37
DM1000 Version 2—Owner’s Manual
3
Operating Basics
Assigning Parameters to the ENCODER MODE [ASSIGN]
button
While the ENCODER MODE [ASSIGN] button indicator is lit, you can use Encoders 1–16
to control a parameter assigned to the [ASSIGN] button. Follow the steps below to assign a
parameter to the [ASSIGN] button.
1 Press the ENCODER MODE [DISPLAY] button.
The Encoder | Encoder page appears. The name of the parameter currently assigned to the
[ASSIGN] button is displayed in the left-hand box. All assignable parameters are displayed
in the right-hand box. (The parameter currently-assigned to the button is highlighted in the
right-hand box.)
2 Use the Parameter wheel or press the [INC]/[DEC] buttons to select a param-
eter in the right-hand box.
A parameter is selected when it appears inside the dotted box. Refer to the next page for a
complete list of assignable parameters.
3 Press [ENTER] to confirm the assignment.
Once assigned, press the ENCODER MODE [ASSIGN] button to turn on the button indi-
cator. You can now use Encoders 1–16 to control the assigned parameter.
Note: When channels that do not feature the currently-assigned parameter are selected, the
Encoders are inactive. For example, if the assigned Encoder parameter is “Phase,” and the Mas-
ter layer is selected, Encoders are inactive, because the Aux Sends and Bus Outs do not feature
Phase parameters.