Yamaha 006IPTO-F0 - Manual (Page 261)

Crossfade via ESAM Commands
261
DM1000 Version 2—Owner’s Manual
Controlling the DM1000 from a V
ideo Editor
19
4 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | Time
Ref page appears.
5 Move the cursor to the FRAMES parameter, then select the desired frame
rate.
The Transition Time transmitted from a video editor is expressed in frames. Match the
frame rate.
6 Press the DISPLAY ACCESS [REMOTE] button repeatedly until the Remote |
ESAM 1-32 page or ESAM 33-48 page appears.
7 Assign Input Channels 1-48 to Machines A-H. (Specify which machine is con-
nected to which channel.)
To add or delete machines to or from Input Channels, move the cursor to a desired machine
(A-H), then press the channel [SEL] button. You cannot assign a channel to multiple
machines.
8 Move the cursor to the REC column, then press [ENTER] to select one REC
machine from Machines A-H.
The REC machine selected here will be used to specify a REC machine via the ESAM com-
mand. You cannot specify multiple REC machines.
Note: These settings are effective only when the DM1000 receives Machine commands. If the
DM1000 receives Source commands that control individual channels, the settings will be
ignored.