Yamaha 006IPTO-F0 - Manual (Page 271)

Setting Preferences
271
DM1000 Version 2—Owner’s Manual
Other Functions
20
• Automix Store Undo
If this check box is on, you can undo the Automix Store & Clear functions.
• Touch Sence Edit In ALL
If this check box is on, all parameters that are turned on in the OVERWRITE section on the
Automix | Main page will be punched in and out via the faders’ Touch Sense function. If this
check box is off, only the faders selected in Fader mode will be punched in and out.
• Drop Out Time
This parameter sets an interval (in frames) between the interruption of incoming timecode
and the stoppage of Automix recording or playback.
• Lock Time
This parameter sets the interval (in frames) allowed until the Automix locks to incoming
timecode messages. If the sync operation is unstable, set this value higher.
• Frame Jump Error
This parameter sets the time interval (in frames) required by the DM1000 to recognize an
error after incoming timecode messages jump. If the actual interval is shorter than the value
specified by this parameter, the DM1000 continues the sync operation. If the frame jump
causes the recording or playback to stop during the MTC sync operation, set the parameter
value higher than the number of frames indicated in the error message.
If you set the parameter to a higher value, adjust the Drop Out Time parameter value, if nec-
essary.
• Fader REC Accuracy
This parameter sets the accuracy of recording faders over time to “Little,” “Some,” “More,”
or “Most.” If you set the parameter to lower values, you will save Automix memory space.
• Insert Time Link to Locate Memory
This parameter selects Locate memories that are applied to the Insert IN/OUT parameters.