Yamaha 006IPTO-F0 - Manual (Page 39)

Metering
39
DM1000 Version 2—Owner’s Manual
3
Operating Basics
Metering
This section describes how to check Input and Output Channel levels using the Meter pages
or an optional MB1000 Peak Meter Bridge.
1 Press the DISPLAY ACCESS [METER] button repeatedly until the Meter | Posi-
tion page appears.
This page enables you to set the metering position for Input and Output Channels.
A INPUT section
This section enables you to select the metering position for Input Channel signals.
B OUTPUT section
This section enables you to select the metering position for Output Channel (Aux Out
1–8, Bus Out 1–8, Stereo Out) signals.
2 Move the cursor to the desired parameter button in the INPUT or OUTPUT
section, then press [ENTER].
You can select one of the following three positions in each section.
• PRE EQ ..........................Immediately before EQ.
• PRE FADER ..................Immediately before the fader.
• POST FADER ...............Immediately after the fader.
3 Press the DISPLAY ACCESS [METER] button repeatedly until the page listed
below that contains the desired channels appears.
- CH1-32 page
- CH33-48 page
These pages display the Input Channel 1–32 levels and Input Channel 33–48 levels
respectively.
- CH1-48 page
This page displays the Input Channel 1–48 levels altogether.
- Master page
This page displays the Output Channel (Aux Out 1–8, Bus Out 1–8, Stereo Out) levels
altogether.
- Effect page
This page displays the internal effects processor 1–4 input and output levels altogether.
Tip: If an optional MB1000 Peak Meter Bridge is installed, changes on this page will be
reflected on the Input & Output Metering Position parameters on the Peak Meter Bridge.
1
2