Yamaha 006IPTO-F0 - Manual (Page 248)

248
Chapter 18—MIDI
DM1000 Version 2—Owner’s Manual
Selecting MIDI Messages for Transmission and Reception
You can select MIDI messages to be transmitted or received at a port specified in the GEN-
ERAL section on the Setup | MIDI/Host page (see page 246).
To do so, press the DISPLAY ACCESS [MIDI] button repeatedly until the MIDI | Setup page
appears.
Select MIDI channels for transmission and reception in the CHANNEL row, and turn the
transmission and reception of each MIDI message on or off using the buttons in the param-
eter rows from PROGRAM CHANGE to OTHER COMMANDS.
A CHANNEL
This parameter row enables you to specify MIDI Channels for MIDI message transmis-
sion and reception. The following parameters are available in this row:
• Tx ................................... This parameter box specifies a MIDI Transmit Channel.
• Rx ................................... This parameter box specifies a MIDI Receive Channel.
B PROGRAM CHANGE
This parameter row enables or disables transmission and reception of Program
Changes.
• Tx ON/OFF................... Transmission of Program Change messages is enabled or dis-
abled.
• Rx ON/OFF................... Reception of Program Change messages is enabled or disabled.
• OMNI ON/OFF............ When this button is turned on, Program Changes on all MIDI
Channels are received regardless of the CHANNEL row set-
tings.
• ECHO ON/OFF ........... This button determines whether Program Change messages
received at the MIDI IN port are echoed through to the MIDI
OUT port.
C CONTROL CHANGE
This parameter row enables or disables transmission and reception of Control Changes.
• Tx ON/OFF................... Transmission of Control Change messages is enabled or dis-
abled.
• Rx ON/OFF................... Reception of Control Change messages is enabled or disabled.
• ECHO ON/OFF ........... This button determines whether Control Change messages
received at the MIDI IN port are echoed through to the MIDI
OUT port.
D PARAMETER CHANGE
This parameter row enables or disables transmission and reception of Parameter
Changes.
1
2
3
4
5
6
7