Yamaha 006IPTO-F0 - Manual (Page 70)

70
Chapter 6—Input Channels
DM1000 Version 2—Owner’s Manual
Panning Input Channels
Input Channels can be panned in the range of L63 through CENTER to R63. To pan each
channel, press the [PAN/SURROUND] button repeatedly until one of the following pages
that contains the desired channels appears.
- Pan1-32 page
This page enables you to set the pan for Input Channels 1–32.
- Pan33-48 page
This page enables you to set the pan for Input Channels 33–48.
The parameters on these two pages (and the procedure for setting them) are the same. Move
the cursor to the desired Pan control, then rotate the Parameter wheel to set the value.
A Pan controls
These knobs adjust the channel pan settings.
Press the [ENTER] button to reset the currently-selected Pan control to center.
B MODE
The MODE parameter determines how paired Input Channels are panned. There are
three Pan modes as follows:
• INDIVIDUAL............... In Individual mode, paired Input Channel
pan controls operate independently.
• GANG............................ In Gang mode, paired Input Channel pan
controls operate in unison, maintaining the
current pan range.
• INV GANG ................... In Inverse Gang mode, paired Input Channel
pan controls operate in unison but move in
opposite directions.
Tip:
• You can use the Encoders to change the Input Channel pan settings (see page 75). This is
useful if you wish to change the pan settings quickly. You can also use the Joystick in the
SELECTED CHANNEL section to change the pan settings, unless the DM1000 is in Sur-
round mode.
• Surround Pan is available when the DM1000 is in Surround mode. Refer to Chapter 11
“Surround Functions” on page 125 for more information on Surround Pan.
2
1