Yamaha 006IPTO-F0 User Manual
Page 278
278
Chapter 20—Other Functions
DM1000 Version 2—Owner’s Manual
At this time, the trigger signal is output from the CONTROL port when you operate the
assigned parameters or controls.
■ Parameters available in the INPUT section
• TALKBACK/DIMMER .......................Same as the MONITOR [TALKBACK] and
[DIMMER] button functions.
• BUS/SLOT ............................................Same as the MONITOR [BUS] and [SLOT] but-
ton functions.
• STEREO/2TRD1/2TRD2....................Same as the MONITOR [STEREO], [2TRD1],
and [2TRD2] button functions.
Tip: Refer to the next page for a complete list of assignable parameters and controls.
No Assign
AUX1 ON
TALKBACK
:
DIMMER
AUX8 ON
BUS
ST ON
SLOT
CH1 ON UNLATCH
STEREO
:
2TRD1
CH48 ON UNLATCH
2TRD2
BUS1 ON UNLATCH
TALKBACK UNLATCH
:
DIMMER UNLATCH
BUS8 ON UNLATCH
BUS UNLATCH
AUX1 ON UNLATCH
SLOT UNLATCH
:
STEREO UNLATCH
AUX8 ON UNLATCH
2TRD1 UNLATCH
ST ON UNLATCH
2TRD2 UNLATCH
UDEF1
CH1 ON
:
:
UDEF12
CH48 ON
BUS1 ON
:
BUS8 ON
Trigger signal polarity =
Output signals from
the CONTROL port
Trigger signal polarity =
Output signals from
the CONTROL port