Yamaha 006IPTO-F0 - Manual (Page 7)

New Functions in DM1000 Version 2
7
DM1000 Version 2—Owner’s Manual
New Functions in DM1000 Version 2
The following functions have been added to the DM1000 as part of the upgrade of the firm-
ware from version 1.0 to version 2.0.
Control Surface
• Encoder mode now features an assignable function, ALT LAYER, which enables you to con-
trol the channel level for all 32 channels without switching between layers.
→ page 36
• There are now 50 assignable Encoder mode parameters.
→ page 38
Aux Sends
• If an Aux Send is set to pre-fader, you can set the Pre point before or after channel mute.
→ page 99
• The AUX SELECT [AUX 1–8] buttons enable you to solo or unsolo Aux Sends without
switching to the Master layer.
→ page 107
Control Room Monitor
• You can select whether the Input Channel’s Pan setting is used when the Input Channel Solo
signal is set to Pre Fader.
→ page 120
• Raising the channel faders for soloed Channels from –
∞ can unsolo the Channels.
→ page 121
• You can simultaneously select 2TR D1 or 2TR D2, and STEREO as control room monitor
sources.
→ page 123
Surround Function
• The on/off status of the Follow Pan button is reflected in the pan and Surround Pan
settings.
→ page 125
• The Surround Monitor function now supports THX Surround.
→ page 138
• You can simultaneously select BUS and SLOT as surround monitor sources.
→ page 137
Group/Link
• The Fader Group Master function enables you to control the overall level of the Fader group
channels simultaneously while maintaining the relative level balance of each channel.
→ page 150
• The Mute Group Master function enables you to mute all channels in a Mute group
simultaneously.
→ page 152
Internal Effects
• You can add optional Add-On Effects to the preset effects.
→ page 161
Scene Memory
• Any channel or parameter settings in the current scene can be copied and pasted into other
scenes.
→ page 171
• You can select additional parameters for the Recall Safe function.
→ page 170