ZyXEL Communications P-334W - Manual (Page 418)

Prestige 334W User’s Guide
36-2 Remote Management
The following table describes the fields in this screen.
Table 36-1 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION EXAMPLE
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service Each of these read-only labels denotes a service or protocol.
Port This field shows the port number for the service or protocol. You may
change the port number if needed, but you must use the same port
number to access the Prestige. 23
Access Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable. LAN Only
(default)
Secure Client
IP The default 0.0.0.0 allows any client to use this service or protocol to
access the Prestige. Enter an IP address to restrict access to a client
with a matching IP address. 0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
36.1.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1. A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
2. You have disabled that service in menu 24.11.
3. The IP address in the Secure Client IP field (menu 24.11) does not match the client IP address. If it
does not match, the Prestige will disconnect the session immediately.
4. There is an SMT console session running.
5. There is already another remote management session with an equal or higher priority running. You
may only have one remote management session running at one time.
6. There is a firewall rule that blocks it.