ZyXEL Communications P-334W - Manual (Page 137)

Prestige 334W User’s Guide
WAN Screens 9-7
The following table describes the labels in this screen.
Table 9-4 PPTP Encapsulation
LABEL DESCRIPTION
ISP Parameters for Internet Access
Encapsulation Point-to-Point Tunneling Protocol (PPTP) is a network protocol that enables secure
transfer of data from a remote client to a private server, creating a Virtual Private
Network (VPN) using TCP/IP-based networks. PPTP supports on-demand, multi-
protocol, and virtual private networking over public networks, such as the Internet.
The Prestige supports only one PPTP server connection at any given time.
To configure a PPTP client, you must configure the User Name and Password
fields for a PPP connection and the PPTP parameters for a PPTP connection.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the User Name above.
Retype to Confirm Type your password again to make sure that you have entered is correctly.
Nailed-up
Connection Select Nailed-Up Connection if you do not want the connection to time out.
Idle Timeout This value specifies the time in seconds that elapses before the Prestige
automatically disconnects from the PPTP server.
PPTP Configuration
My IP Address Type the (static) IP address assigned to you by your ISP.
My IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the Prestige.
Server IP Address Type the IP address of the PPTP server.
Connection ID/Name Type your identification name for the PPTP server.
Apply Click Apply to save your changes back to the Prestige.
Reset Click Reset to begin configuring this screen afresh.
9.5 Configuring WAN IP
To change your Prestige’s WAN IP settings, click WAN, then the WAN IP tab. This screen varies according
to the type of encapsulation you select.
If your ISP did not assign you a fixed IP address, click Get automatically from ISP (Default);otherwise
click Use fixed IP Address and enter the IP address in the field provided.