ZyXEL Communications P-334W - Manual (Page 201)

Prestige 334W User’s Guide
Remote Management Screens 14-11
Table 14-5 Remote Management: SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Trusted Host If you enter a trusted host, your Prestige will only respond to SNMP messages from
this address. A blank (default) field means your Prestige will respond to all SNMP
messages it receives, regardless of source.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Service Access Select the interface(s) through which a computer may access the Prestige using this
service.
Secured Client
IP Address A secured client is a “trusted” computer that is allowed to communicate with the
Prestige using this service.
Select All to allow any computer to access the Prestige using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the Prestige using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
14.7 Configuring DNS
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and vice versa.
Refer to the chapter on Wizard Setup for background information.