RAD Data comm IPmux-1 User Manual

Page 78

Chapter 5 Application Configuration Procedures

IPmux-1/1E Installation and Operation Manual

5-12 IPmux-4

PHYSICAL LAYER CONFIGURATION

1. Channel Status

Enable

2. Transmit Clock Source

Loopback

3. Loopback State

Disable

4. Rx. Sensitivity

–10dB

5. Channel Type

CRC4 Disable

6. Idle Code

7. Signaling Mode

CAS Disable

8. Cond. Data pattern

9. Cond. CAS (ABCD) pattern 01

ESC. Exit

Current port is the USER PORT, Channel #2

Select item from the menu.

Figure 5-6. Physical Layer Configuration Menu

DS0 Bundle Configuration

➤

To configure DS0 Bundles for Station A:
1. From the Configuration menu select 2 DS0 Bundle Configuration (refer to

Figure 5-4).

2. From the DS0 Bundle Configuration menu, press 1.
3. Select Bundle ID and type 32.
4. Select Time slot number type 1–10.
5. Select Time slot Current Status and choose SET.
6. Press <S> to Save.

Remember to press <Enter> after modifying each parameter. Press <S> to save

all changes on the menu.

➤

To configure DS0 Bundles for Station B:
1. From the DS0 Bundle Configuration menu, press 1 (refer to Figure 5-4).
2. Select Bundle ID and type 33.
3. Select Time slot number type 11–20.
4. Select Time slot Current Status and choose SET.
5. Press <S> to Save.
6. Press <Esc> to return to the Configuration menu.

Main Menu

↓

2. Configuration

↓↓↓↓

2. DS0 Bundle
Configuration

Note

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610