RAD Data comm IPmux-1 - Manual (Page 105)

IPmux-1/1E Installation and Operation Manual Appendix E Parameters and Screens
General Configuration E-7
Default Gateway
Default gateway defines the management next hop. When next hop is not defined
for the bundle connection the default gateway address will be used.
➤ To configure the default gateway:
1. Type 2 (Default Gateway) in the General Configuration menu.
2. Enter the Default Gateway IP address.
The Default Gateway must be in the same subnet as the Host.
Authentication/Community
AUTHENTICATION/COMMUNITY
1. Authentication Failure Trap Off
2. Trap public
3. Read public
4. Write public
Select item from the menu.
Use key or keys <1> to <4>
Figure E-10. Authentication/Community Menu
Table E-2. Authentication/Community Parameters
Parameter Possible Values Remarks
Authentication
Failure Trap On
Off On – an authentication-failure trap is generated
when a system manager attempts to set a
parameter within IPmux-1/1E with an incorrect
community value
Trap Up to 10 alphanumeric characters The entry is case-sensitive
Read Up to 10 alphanumeric characters The entry is case-sensitive
Write Up to 10 alphanumeric characters The entry is case-sensitive
Main Menu
↓
2. Configuration
↓
1. General
Configuration
↓
2. Default
Gateway
Main Menu
↓
2. Configuration
↓
1. General
Configuration
↓
3. Management
Configuration
↓
1. Authentication/
Community
Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com