RAD Data comm IPmux-1 - Manual (Page 37)

Site Requirements and Prerequisites 2-1
Chapter 2
Installation
This chapter includes:
• Site requirements and prerequisites
• Package contents
• Equipment needed
• Installation and setup
2.1 Introduction
IPmux-1/1E is delivered completely assembled for bench-top installation. The only
mechanical installation procedures that may be necessary are optional installation
in a 19-in rack. For rack installation instructions refer to the Rack Mounting Kit for
19-inch Racks guide that comes with the RM kit.
After installing the unit, configure IPmux-1/1E using an ASCII terminal connected
to the IPmux-1/E Control port, or Telnet or RADview TDMoIP management
application. The IPmux-1/1E configuration procedures are described in Chapter 3
and Appendix E of this manual. Configuration parameters are explained in
Appendix E.
If problems are encountered, refer to Chapter 4 for test and diagnostics
instructions.
No internal settings, adjustment, maintenance and repairs may be performed
by either the operator or the user; such activities may be performed only by
skilled service personnel who are aware of the hazards involved.
Always observe standard safety precautions during installation, operation, and
maintenance of this product.
2.2 Site Requirements and Prerequisites
Install AC-powered IPmux-1/1E units within 1.5m (5 feet) of an easily-accessible
grounded AC outlet capable of furnishing the required supply voltage, in the range
of 100 to 240 VAC.
DC-powered IPmux-1 units require a 48 VDC power source. The positive pole can
be earthed.
Warning
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com