RAD Data comm IPmux-1 User Manual
Page 72
Chapter 5 Application Configuration Procedures
IPmux-1/1E Installation and Operation Manual
5-6 IPmux-1
E1/T1 Configuration
➤
To configure E1/T1:
1. From the Main menu, select 2 Configuration.
2. From the Configuration menu select 2 E1/T1 Configuration (see Figure 5-3).
3. Select Transmit Clock and choose Adaptive.
4. Select Line Type and choose CRC4 Disable.
5. Select Signaling Mode and choose CAS Disable.
6. Press <S> to save the configuration.
7. Press <Esc> a number of times to return to the Configuration screen.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
E1/T1 CONFIGURATION
1. Channel Status
Enable
2. Transmit Clock Source
Adaptive
3. Loopback State
Disable
4. Rx. Sensitivity
-10dB
5. Line Type
CRC4 Disable
6. Idle Code
7E
7. Signaling Mode
CAS Disable
8. Cond. Data pattern
FF
9. Cond. Cas
ESC. Exit
Select item from the menu.
Figure 5-3. E1/T1 Configuration Menu
DS0 Bundle Configuration
➤
To create the bundles:
1. From the Configuration menu select 5 DS0 Bundle Configuration (see
Figure 5-4).
2. Select Time slot number and enter 1 – 10.
3. Select Time slot Current Status and choose Set.
4. Press <S> to Save.
5. Press <Esc> to return to the Configuration screen.
Main Menu
↓
2. Configuration
↓↓↓↓
2. E1/T1
Configuration
Main Menu
↓
2. Configuration
↓↓↓↓
5. DS0 Bundle
Configuration
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com