Roland G-70 - Manual (Page 191)

Style Track Edit functions
G-70 Music Workstation r
191
(3) Press the [TRACK¥EDIT] field.
(4) Press a field in the top two rows to select the
desired STYLE TRACK EDIT function.
If, after selecting one of these functions and setting
parameter values, you decide not to execute the
transformation, do not press the [EXECUTE] field.
(5) Select the track(s), Mode(s) and Division(s) you
wish to modify.
(6) Select the range (“FROM” and “TO”) for the edit
operation.
The FROM and TO parameters allow you to specify
the positions (measure/beat/clock) of the track
excerpt you want to change.
Example: to change measures 1~4 of the selected
track, enter the following values:
(7) Specify what you want to change and how it
should change: press one of the parameter fields
(to the right of the FROM/TO section) use the
[DATA÷ENTRY] dial or the [DEC]/[INC] buttons.
(8) Confirm the operation by pressing the [EXECUTE]
field.
(9) Save your Style.
This Quantize function can be used after recording a
part if you don’t feel comfortable with the timing of
what you played. If only certain notes in a given time
range need to be quantized, you should narrow down
the edit range using the FROM/TO parameters.
■TRACK (ADrums~Acc6, ALL)
Allows you to select the track you want to edit. Select “ALL”
to edit all tracks.
■MODE
Allows you to select the mode of the pattern to be edited:
“Major”, “minor” or “7th”.
■DIVISION
Use this parameter to select the Division (or pattern) you
want to edit: Intro 1~4, Main 1~4, Fill Dwn 1~3, Fill Up 1~
3, End 1~4.
■FROM
● BAR (1~[last measure of the track or pattern])—Refers
to the first measure to be edited. By default, the FROM
value is set to the beginning of the selected track(s).
● BEAT (1~[number of beats per bar])—Specifies the
beat position. The number of selectable beats depends
on the time signature in the selected area.
● CPT (1~119)—Refers to the starting CPT position. “CPT”
is short for “Clock Pulse Time”, the smallest unit used by
the G-70. (There are 120 CPTs to every beat of a bar.)
Change this setting only if your edit operation should
start after the selected beat.
■TO
By default, the TO position is set to the last event of the
selected track (or the last event of the longest track when
you select “ALL”).
● BAR (1~[last measure of the track or pattern])—This is
where you specify the last measure to be edited.
● BEAT (1~[number of beats per bar])—Specifies the
beat position. The number of selectable beats depends
on the time signature in the selected area.
● CPT (1~119)—Refers to the last clock that should be
affected by the edit operation. Change this setting only
if your edit operation should not end exactly on the
selected beat.
■FROM NOTE (0 C-~127 G9)
This parameter allows you to set the note (or lower limit of
the note range) to be modified within the specified FROM/
TO time range. The note can also be selected by pressing
the corresponding key after selecting the FROM NOTE field.
FROM: BAR= 0001
BEAT= 01
CPT= 000
TO: BAR= 0005
BEAT= 01
CPT= 000
QUANTIZE