Wire stretching, Selecting and deleting wires, Wire stretching -5 selecting and deleting wires -5 – National Instruments BridgeVIEW User Manual
Page 213
Chapter 9
Creating VIs
© National Instruments Corporation
9-5
Note
When you place the Wiring tool over a node, G displays wire stubs that indicate
each input and output. The wire stub has a dot at its end if it is an input to the node.
Wire Stretching
You can move wired objects individually or in groups by dragging the
selected objects to a new location with the Positioning tool.
Selecting and Deleting Wires
You might wire nodes incorrectly. If you do, select the wire you want to
delete and then press
vertical piece of wire. The point where three or four wire segments join is
called a junction. A wire branch contains all the wire segments from one
junction to another, from a terminal to the next junction, or from one
terminal to another if there are no junctions in between. You select a wire
segment by clicking on it with the Positioning tool. Double-clicking selects
a branch, and triple-clicking selects the entire wire.
VI
Tip Strip
Wiring Tool