NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 78)

3-4 Setting Up Your Server
Do not install the rack in the places listed below. Installing the rack or mounting the server on the
rack in such a place may cause some malfunction to occur.
„
Narrow space from which devices cannot be pulled out from the rack completely
„ Place that cannot bear the total weights of the rack and devices mounted on the rack
„ Place where stabilizers cannot be installed or where the rack can be installed only after the
practice of proper earthquake-resistant construction
„ Place of uneven or slanting floor
„ Place of drastic temperature change (near a heater, air conditioner, or refrigerator)
„
Place where intense vibration may be generated
„ Place where corrosive gas is generated, chemicals are nearby, or chemicals may be
accidentally sprayed over
„ Place where a carpet not subject to anti-static process is laid.
„ Place where some objects may be fallen on the rack
„ Place near a device generating intense magnetic field (such as a TV, radio,
broadcast/communication antenna, power transmission wire, and electromagnetic crane) is
placed (If unavoidable, contact your service representative to request proper shield
construction.)
„ Place where the power cord of the server must be connected to an AC outlet that shares
the outlet of another device with large power consumption.
„
Place near equipment that generates power noise (e.g., contact spark at power-on/power-
off of commercial power supply through a relay). If you must install the server close to
such equipment, request your service representative for separate power cabling or noise
filter installation.