NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 306)

9-32 Upgrading Your Server
„ If a bootable PCI board (e.g., a disk array controller, SCSI controller, or LAN card) is
additionally installed, the boot priority is changed to the default. After the additional
installation, start the BIOS SETUP utility, select [Boot] → [Boot Device Priority], and set
the new boot priority.
„
If an option operating with only 33 MHz is installed in one of the slots (1C, 2C, and 3C,
or 1B, 2B, and 3B) on a PCI riser card, the options installed in the other slots of the same
riser card are subjected to operation with only 33 MHz.
„ Contact your service representative for the acceptable optional PCI board.