NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 309)

Upgrading Your Server 9-35
8. Install the PCI board on the riser card.
Align the PCI board terminal section with the riser card slot, and firmly push the PCI
board until it is fully seated.
IMPORTANT:
„
Do not touch the terminals of the riser cards and PCI boards with
your bare hand. Fingerprints and dust left on them cause the server
to malfunction.
„ If you are unable to install a PCI board correctly, remove it, and
then install it again. Be careful not to apply excess force to a PCI
board or riser card. Doing so may damage the card.
NOTES:
„ Confirm that the slit in the PCI board bracket is positioned by the
embossed part. (This applies to other card brackets and extension
slot covers.)
„ Confirm that the top end of the PCI board bracket is inserted in the
designated slot of the riser card.
„
If a full-height PCI board is installed, confirm that the PCI board
bracket and the edge of the opposite card are inserted in the guide
rails of the riser card.
Embossed Embossed
Guide
rails
Slit in the PCI
board bracket Slit in the PCI
board bracket
Top end of the
PCI board bracket
Low-profile type Full-height type