NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 395)

Installing Windows 2000 F-9
Updating the System - Installing Service Pack -
IMPORTANT: This system does not support Windows 2000 Service
Pack 1 - 3.
If you install Windows 2000 CD-ROM which contains Service Pack 4
to your system, you do not have to apply Service Pack 4 again.
NOTE: If you run the Update of System with the MO device
connected, refer following attention.
Remove MO media from the MO device immediately after clicking on
[Restart Computer].
If the message "There is no disk in the drive. ..." is shown during the
Update of System, click [Cancel] or [Continue] and continue the
update.
To ensure normal system operation you should update your system using the following procedures.
1. Logon to the system using the administrator account or other account which is a member
of the Administrators group.
2. Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive.
Master Control Menu is automatically appeared on the screen.
3. Click on [Setup] with left mouse button and click on [Update NEC Express5800 system]
section.
4. Continue your work for system update as the following message.
5. Click on [Restart Computer] to restart the system.
6. Remove the NEC EXPRESSBUILDER CD-ROM from the CD-ROM drive immediately
after clicking on [Restart Computer]
IMPORTANT: If you change the configuration of the system (by
adding or removing hardware or Operating system software
components) or repair the system, you must run the system update
again.