NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 206)

6-8 Installing and Using Utilities
– Create Maintenance Partition
NEC EXPRESSBUILDER creates about 55MB of the maintenance partition on the
system disk (or disk array system) as work area. The various utilities are installed
when the maintenance partition is created successfully or when the maintenance
partition is already created.
– Install Maintenance Partition Utilities
Various utilities are installed in the maintenance partition from the CD-ROM.
– Update Maintenance Partition Utilities
Various utilities are copied in the Maintenance Partition from the update disk. This
menu is only used when the update disk is supplied from your service representative or
attached with your system.
– FDISK
Execute FDISK command of ROM-DOS system. You can create/delete partitions,
etc.
„ BIOS/FW/etc. Update
This menu allows you to update the software module such as BIOS and firmware of the
server by using the update disk (3.5-inch floppy disk) that is distributed from NEC
customer service representative.
After rebooting the system, an update program is started automatically from the floppy
disk, and the various BIOS and firmware programs are updated.
IMPORTANT: Do not turn off the server while the update program
is running. If the update processing is discontinued, the system
becomes unable to start.
„ Initialize Remote Management Card
"Initialize Remote Management Card" is used to configure the Remote Management Card
with correct parameters of the system installed it.
„ System Management
The parameters of BMC (Baseboard Management Controller) are set for remote control
and alert.
„ Help
Displays explanations about various functions of NEC EXPRESSBUILDER.
„ Return to the Top Menu
Choosing this menu returns to the Top Menu.