NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 117)

Configuring Your Server 4-21
Exiting the Utility
To exit the utility, press Esc until a message prompts you to exit (if you changed any setting, you
are prompted to save the changes before you exit).
Configure/View SCSI Controller Settings
The Configure/View Host Adapter Settings has the following menu items and parameters. Read
descriptions to select a correct parameter for each menu item.
SCSI Bus Interface Definitions
To set three menu items under "SCSI Bus Interface Definitions", select a menu item with the cursor
keys (↓ or ↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.
The following table lists menu items, available parameters, and descriptions.
Menu item Parameter Description
SCSI Controller ID 0 - [7] - 15 Select "7".
SCSI Controller Parity [Enabled]
Disabled Select "Enabled".
SCSI Controller
Termination [Enabled]
Disabled Enable or disable the SCSI termination.
Select "Enabled".
[ ]: Factory-set
Additional Options
To set three menu items under "Additional Options", select a menu item with the cursor keys (↓ or
↑) and press Enter to display its submenu. Then, select a submenu item with the cursor keys (↓ or
↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.
„ Boot Device Configuration
Move the cursor onto "Boot Device Configuration" and press Enter to display the
submenu. The Boot Device Configuration submenu allows you to select the device
connected to the channel A or B as a boot device. Always select "AIC-7902 A".