National Instruments AT-MIO-16X User Manual

Page 322

Index

I-13

AT-MIO-16X User Manual

immediate update mode, 3-18
input configurations. See also CONFIGMEM

available input modes, 2-7 to 2-10

DIFF (table), 2-8
NRSE (table), 2-8
RSE (table), 2-8

common-mode signal rejection, 2-29
differential connections

DIFF input configuration, 2-22
floating signal sources, 2-24 to 2-26
ground-referenced signal

sources, 2-23

nonreferenced signal sources,

2-24 to 2-26

recommended configuration (table), 2-22
single-ended connections, 2-26 to 2-27

floating signal sources (RSE

configuration), 2-27

grounded signal sources (NRSE

configuration), 2-28

input multiplexer

address selection bits (CHANSEL

<3..0>), 4-36 to 4-37

description, 3-6

input polarity and range, 2-10 to 2-11

actual range and measurement precision

(table), 2-11

selection considerations, 2-10

installation. See also configuration.

hardware installation, 2-13
unpacking AT-MIO-16X, 1-7

INTCHB<2..0> bits, 4-19
internal update counter, selecting, 5-32
interrupts

controlling with bits in Command

interrupt channel selection, 2-7
interrupt level selection (table), 4-19

PC I/O channel interface, 3-4
programming, 5-43

interval channel scanning

definition, 5-10
programming, 5-12 to 5-14

interval scanning data acquisition timing, 3-14
INTGATE bit, 4-6
I/O connectors

cabling considerations

50-pin I/O connector, 2-43 to 2-44
68-pin I/O connector, 2-44

exceeding maximum ratings

(warning), 2-14

pin assignments

50-pin connector (figure), 2-15, B-2
68-pin connector (figure), 2-16, B-3

signal descriptions (table), 2-17 to 2-19

I/O_INT bit, 4-15

LabVIEW and LabWindows/CVI

software, 1-4

LASTONE bit, 5-16
linear errors

equivalent gain errors in 16-bit systems

(table), A-4

equivalent offset errors in 16-bit systems

(table), A-3

gain error, A-3
postgain offset error, A-3
pregain offset error, A-3

manual. See documentation.
multiple-analog input channel configurations,

programming, 5-15 to 5-16

multiple-channel data acquisition timing,

3-12 to 3-15

continuous scanning, 3-13