National Instruments AT-MIO-16X User Manual

Page 315

Index

AT-MIO-16X User Manual

I-6

Configuration Memory Depth Field

(figure), 6-5

EEPROM map, 6-2
factory area information (table),

6-2 to 6-4

Revision and Subrevision field

(figure), 6-5

storage area, 6-4

equipment requirements, 6-7 to 6-8
input calibration, 3-7 to 3-8
output calibration, 3-17 to 3-18,

6-10 to 6-11

reference calibration, 6-8 to 6-9

CFGMEMEF* bit, 4-29
CHAN_AIS bit, 4-35
CHAN_BIP bit, 4-36
CHAN_CAL bit, 4-35
CHAN_DSP bit, 4-38 to 4-39
CHAN_GHOST bit, 4-38
CHAN_LAST bit

description, 4-38
programming multiple-analog input

channel configurations, 5-15

channel scanning. See data acquisition

programming.

CHAN_SE bit, 4-35
CHANSEL<3..0> bits, 4-36 to 4-37
CH_GAIN<2..0> bits, 4-37 to 4-38
CLKMODEB<1..0> bits, 4-20 to 4-21
CNT32/16* bit

description, 4-7 to 4-8
sample counting, 5-18, 5-19

Command Register 1, 4-5 to 4-8
Command Register 2

description, 4-9 to 4-12
interrupt programming, 5-43
programming digital I/O circuitry, 5-36

Command Register 3, 4-13 to 4-19
Command Register 4, 4-20 to 4-24
common-mode signal rejection, 2-29

ComponentWorks software, 1-4
concatenating counters, 2-39
CONFIGCLK signal, 3-29
CONFIGMEM Register

description, 4-35 to 4-40
programming

multiple-analog input channel

configurations, 5-16

single-analog input channel

configurations, 5-15

CONFIGMEMCLR Register

description, 4-47
programming

multiple-analog input channel

configurations, 5-16

single-analog input channel

configurations, 5-15

CONFIGMEMLD Register

description, 4-48
programming

multiple-analog input channel

configurations, 5-16

single-analog input channel

configurations, 5-15

configuration. See also input configurations;

installation; signal connections.

analog input, 2-7 to 2-11

considerations for selecting input

ranges, 2-10

input modes, 2-7 to 2-10
input polarity and range, 2-10 to 2-11

analog output, 2-11 to 2-12

output polarity selection, 2-12
reference selection, 2-11

AT bus interface, 2-2 to 2-3
base I/O address selection, 2-3 to 2-6

changing software to match

(note), 2-4

default settings of National

Instruments products (table),
2-4 to 2-5