National Instruments AT-MIO-16X - Manual (Page 11)

Table of Contents
AT-MIO-16X User Manual xii © National Instruments Corporation
Figure 5-7. Cyclic Waveform Programming ........................................................... 5-27
Figure 5-8. Programmed Cycle Waveform Programming ....................................... 5-29
Figure 5-9. Pulsed Cyclic Waveform Programming ................................................ 5-31
Figure 5-10. RTSI Switch Control Pattern................................................................. 5-40
Figure 6-1. AT-MIO-16X EEPROM Map............................................................... 6-2
Figure 6-2. Revision and Subrevision Field............................................................. 6-5
Figure 6-3. Configuration Memory Depth Field...................................................... 6-5
Figure 6-4. ADC and DAC FIFO Depth Field......................................................... 6-6
Figure 6-5. Area Information Field .......................................................................... 6-6
Figure B-1. AT-MIO-16X 50-Pin I/O Connector..................................................... B-2
Figure B-2. AT-MIO-16X 68-Pin I/O Connector..................................................... B-3
Tables
Table 2-1. Default Settings of National Instruments Products for the PC.............. 2-4
Table 2-2. Switch Settings with Corresponding Base I/O Address and
Base I/O Address Space ........................................................................ 2-5
Table 2-3. Available Input Configurations for the AT-MIO-16X.......................... 2-8
Table 2-4. Actual Range and Measurement Precision Versus Input Range
Selection and Gain................................................................................. 2-11
Table 2-5. Recommended Input Configurations for Ground-Referenced and
Floating Signal Sources......................................................................... 2-22
Table 4-1. AT-MIO-16X Register Map.................................................................. 4-1
Table 4-2. DMA Channel Selection ....................................................................... 4-12
Table 4-3. DMA and Interrupt Modes .................................................................... 4-16
Table 4-4. Interrupt Level Selection ....................................................................... 4-19
Table 4-5. Board and RTSI Clock Selection .......................................................... 4-21
Table 4-6. Analog Output Waveform Modes ......................................................... 4-22
Table 4-7. Straight Binary Mode A/D Conversion Values..................................... 4-33
Table 4-8. Two’s Complement Mode A/D Conversion Values ............................. 4-34
Table 4-9. Input Configuration ............................................................................... 4-39
Table 4-10. Analog Output Voltage Versus Digital Code (Unipolar Mode)............ 4-42
Table 4-11. Analog Output Voltage Versus Digital Code (Bipolar Mode) .............. 4-42
Table 5-1. Am9513A Counter/Timer Allocations .................................................. 5-2
Table 5-2. RTSI Switch Signal Connections .......................................................... 5-38
Table 6-1. EEPROM Factory Area Information..................................................... 6-2
Table 6-2. Calibration DACs .................................................................................. 6-8