Rtsi switch strobe register, Rtsi switch strobe register -73, Programming the waveform cycle counter -34 – National Instruments AT-MIO-16X User Manual

Page 169

Text mode
Original mode

Chapter 4

4-73

AT-MIO-16X User Manual

RTSI Switch Strobe Register

The RTSI Switch Strobe Register is written to in order to load the
contents of the RTSI Switch Shift Register into the RTSI Switch
Control Register, thereby updating the RTSI switch routing pattern. The
RTSI Switch Strobe Register is written to after shifting the 56-bit
routing pattern into the RTSI Switch Shift Register.

Address:

Base address + 0E (hex)

Type:

Write-only

Word Size:

8-bit

Bit Map:

Not applicable, no bits used