Paradyne ACCULINK 316x - Manual (Page 75)

Operation
3-33 3160-A2-GB22-10 December 1996
Customer ID: New Cust main/configuration/edit/snmp/traps
Model: ACCULINK XXXX
Save Edit Main Previous Cntrl–x to Disconnect
Trap Options
Number of Trap Managers: 6
Clear
Clear
Clear
Clear
Clear
Clear
General Traps: _____
Trap Manager 1 IP Address: . . .
Trap Manager 2 IP Address: . . .
Trap Manager 3 IP Address: . . .
Trap Manager 4 IP Address: . . .
Trap Manager 5 IP Address: . . .
Trap Manager 6 IP Address: . . . 000 000 000 000
Enterprise Specific Traps: _____
Link Traps: _____
Link Trap Interfaces: _____
Both
Enable
Both
Both
Figure 3-23. Trap Options Screen
Configuring an IP Address for SNMP Trap
Manager
An IP address must be configured for each SNMP trap
manager specified. This configuration option is displayed
for the number of trap managers specified by the Number
of Trap Managers configuration option.
To configure an IP address for the SNMP trap
manager:
1. Press F3 to select Cnfig from the top-level menu
screen.
F1
DSU ESF
Stat
Test Cnfig
F2 F3
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
function key. Use the scroll keys, if necessary.
F1
Load from:
Activ
Cust Fact1
F2 F3
3. Press F1 to select Edit.
F1
Choose Funct:
Edit
Save
F2 F3
4. Press the key from the Edit screen to display
the SNMP selection.
F1
Edit:
DTE
Port NET
F2 F3
5. Press F3 to select SNMP.
F1
Edit:
User
Alarm SNMP
F2 F3
6. Press F2 to select Trap from the SNMP Config
screen.
F1
SNMP Config:
Gen
Trap
F2 F3
7. Press the F1 (Next) key until the Trap n IP
Address configuration option appears.
F1
Num Trap Mgrs:1
Next
1 2
F2 F3