Paradyne ACCULINK 316x - Manual (Page 108)

ACCULINK 316x DSU/CSU
3-66 December 1996 3160-A2-GB22-10
Disconnecting the Modem Connection
The Disconnect command enables you to force a
disconnect of an active modem connection from the front
panel of the DSU/CSU. This command is only available
when the DSU/CSU modem is connected, either through
alarm dial out, front panel pass-through, or remote access.
The Disconnect function is not used for Model 3161
DSU/CSUs since an integral modem is not available.
There are two methods of disconnection,
•
Using the Disconnect command via the front panel
menu or async terminal interface.
•
Pressing and holding the and front panel
keys simultaneously, or using the Passthrough
Disconnect button on a PC running Front Panel
Emulation software.
Use the Disconnect command for most pass-through
connections and all dial connections. You must use the
front panel keys when a pass-through connection to a
remote device other than a 3160/3164 DSU/CSU is
established. You cannot use the front panel keys for dial
connections.
Disconnecting Using the Disconnect Command
To disconnect an established modem connection using
the Disconnect command,
1. Press the key from the top-level menu screen
to bring the Ctrl branch onto the front panel LCD.
F1
DSU ESF
Stat
Test Cnfig
F2 F3
2. Press F3 to select Ctrl from the top-level menu
screen.
F1
DSU ESF
Test
Cnfig Ctrl
F2 F3
3. From the Call Setup screen, press F1 to select
Disc.
F1
Call Setup:
Disc
ChDir
F2 F3
The modem call is disconnected and the
Command Complete screen appears.
F1
Disconnect:
Command Complete
F2 F3
Disconnecting Using Front Panel Keys
To disconnect a modem connection using two keys,
from the front panel keypad, press the and keys
simultaneously and hold for two seconds. From a front
panel PC Emulation screen, click on the Disconnect
button.
F1
Call Setup:
Disc
ChDir
F2 F3
The modem call is disconnected and the Command
Complete screen appears.
F1
Disconnect:
Command Complete
F2 F3