Paradyne ACCULINK 316x - Manual (Page 106)

ACCULINK 316x DSU/CSU
3-64 December 1996 3160-A2-GB22-10
3. From the Control screen, press F1 to select Call.
F1
Control:
Call
Rel LED
F2 F3
4. From the Call Setup screen, press F1 to select
Pass.
F1
Call Setup:
Pass
Dial ChDir
F2 F3
5. From the Pass Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
F1
Pass n: xxxxxxxxx
Up Down Dial
F2 F3
6. When the number of the desired directory appears
on the screen, press F3 (Dial) to place the call.
Initiating a Call for PC, ASCII Terminal/Printer,
Async Terminal, or SNMP Operation
Use the Dial command to set up a semipermanent
connection to route alarm messages to the specified
destination. The Dial command initiates a call through the
integral modem to a PC, ASCII terminal/printer, or async
terminal.
To initiate a call at the local DSU/CSU,
1. Press the key on the top-level menu screen to
bring the Ctrl branch onto the front panel LCD.
F1
DSU ESF
Stat
Test Cnfig
F2 F3
2. Press F3 to select Ctrl from the top-level menu
screen.
F1
DSU ESF
Test
Cnfig Ctrl
F2 F3
3. From the Control screen, press F1 to select Call.
F1
Control:
Call
Rel LED
F2 F3
4. From the Call Setup screen, press F2 to select
Dial. This selection is not available if the
DSU/CSU’s integral modem is currently active.
F1
Call Setup:
Pass
Dial ChDir
F2 F3
5. From the Dial Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
F1
Dial n: xxxxxxxxx
Up Down Dial
F2 F3