Paradyne ACCULINK 316x - Manual (Page 178)

ACCULINK 316x DSU/CSU
D-14 December 1996 3160-A2-GB22-10
Power Cable
The power cable is a 14.5-foot, 18 AWG stranded
cable. The connector is terminated at one end with a
6-position Molex 39-01-2060 connector. The other end of
the cable is terminated with a bare wire that should be
connected to a DC power source. Figure D-9 shows the
wire colors. The power source can be either a single
source of +24 Vdc or up to two sources of –48 Vdc
(A and B). You cannot connect +24 Vdc and – 48 Vdc to
the same unit. See the installation instructions in
Chapter 2, Installation.
Figure D-9. DC Power Cable
(Feature Number 3100-F1-520)
Power Input Connector
The required input power connector leads are shown in
Table D-10.
Table D-10
DC Power Connector
Signal Pin Number
– 48 Vdc Return 1,2
– 48 Vdc A 6
– 48 Vdc B 5
+24 Vdc 5
+24 Vdc Return 4
Chassis Ground 3