3 default configuration changes, 4 initially connecting to the access point, Default configuration changes -3 – Symbol Technologies AP-5131 User Manual
Page 65: Initially connecting to the access point -3

Getting Started
3-3
3.3 Default Configuration Changes
The following table illustrates the changes made to the AP-5131 version 1.1 configuration as
compared to the 1.0 version configuration:
3.4 Initially Connecting to the Access Point
3.4.1 Connecting to the Access Point using the WAN Port
To initially connect to the AP-5131 using the access point’s WAN port:
1.
Connect AC power to the AP-5131, as Power-Over-Ether support is not available on the WAN
port.
2.
Start a browser and enter the AP-5131’s static IP WAN address (10.1.1.1). The default
password is “
symbol
.”
3.
Refer to
Basic Device Configuration on page 3-5
for instructions on the initial (basic)
configuration of the AP-5131.
Version 1.0
Version 1.1
WAN
DHCP client
Auto-Update Enabled
Static IP: 10.1.1.1
Static Mask: 255.0.0.0
LAN 1
Static IP: 192.168.0.1
Static Mask: 255.255.255.0
DHCP Server Enabled
DHCP Client
Auto-Update Enabled
Default Gateway
Ethernet Port Enabled
LAN 2
Not applicable in 1.0 release
Static IP: 192.168.1.1
Static Mask: 255.255.255.0
DHCP Server Enabled
Access via WAN
port
HTTPS, SSH, SNMP: Enabled
HTTP, HTTPS, SSH, SNMP, Telnet:
Enabled
NOTE
The procedures described below assume this is the first time you are
connecting to the access point.