Symbol Technologies AP-5131 - Manual (Page 449)

Command Line Interface Reference 8-155
AP5131>admin(system.snmp.access)> add
Description:
Adds SNMP access entries for specific v1v2 and v3 user definitions.
Syntax:
For information on configuring SNMP access settings using the applet (GUI), see Configuring SNMP Access Control on page 4-23 .
add acl Adds an entry to the SNMP access control list with as the starting IP address and
and as the ending IP address.
v1v2c
Adds an SNMP v1/v2c configuration with as the community (1-31 characters), the
read/write access set to
ro (read only) or rw (read/write), and the Object Identifier (a
string of 1-127 numbers separated by dot, such as 2.3.4.5.6).
v3
Adds an SNMP v3 user definition with the username (1 to 31 characters), access set
to
ro (read only) or rw (read/write), the object ID set to (1 to 127 chars in dot notation,
such as 1.3.6.1), the security type set to one of no auth , authnopriv , or auth/priv .
The following parameters must be specified if is not none :
Authentication type set to md5 or sha1
Authentication password (8 to 31 chars)
The following parameters must be specified if is set to auth/priv :
Privacy algorithm set to des or aes
Privacy password (8 to 31 chars)