Symbol Technologies AP-5131 - Manual (Page 335)

Command Line Interface Reference 8-41
AP5131>admin(network.wan)> set
Description:
Defines the configuration of the AP-5131 WAN port.
Syntax:
Example:
admin(network.wan)>
admin(network.wan)> set dhcp disable
admin(network.wan)> set ipadr 157.169.22.5
admin(network.wan)> set dgw 157.169.22.1
admin(network.wan)> set dns 1 157.169.22.2
admin(network.wan)> set mask 255.255.255.000
admin(network.wan)> set pppoe mode enable
admin(network.wan)> set pppoe type chap
admin(network.wan)> set pppoe user jk
admin(network.wan)> set pppoe passwd @#$goodpassword%$#
admin(network.wan)> set pppoe ka enable
admin(network.wan)> set pppoe idle 600
For an overview of the AP-5131 WAN configuration options available using the applet (GUI), see Configuring WAN Settings on page
5-14 .
set wan enable / disable Enables or disables the AP-5131 WAN port.
dhcp enable / disable Enables or disables WAN DHCP Client mode.
ipadr Sets up to 8 (using from 1 to 8 ) IP addresses for the
AP-5131 WAN interface.
mask Sets the subnet mask for the AP-5131 WAN interface.
dgw Sets the default gateway IP address to .
dns Sets the IP address of one or two DNS servers, where indicates
either the primary (
1 ) or secondary ( 2 ) server, and is the IP
address of the server.
pppoe mode enable / disable Enables or disables PPPoE.
user Sets PPPoE user name.
passwd Defines the PPPoE password.
ka enable / disable Enables or disables PPPoE keepalive.
idle Sets PPPoE idle time.
type Sets PPPoE authentication type.