SMC Networks TigerSwitch 100 - Manual (Page 56)

C
ONFIGURING THE
S
WITCH
2-26
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, and set the startup file name on the switch. If you download the
startup configuration file under a new file name, you can set this file as the
startup file at a later time, and then restart the switch.
Copying the Running Configuration to a File
You can save the current running configuration to a new file name and
then set it as the startup file. Enter a name for the new configuration file,
and then click Copy to File.
Console#copy tftp startup-config 3-18
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system config: startup2.0
3-24
Console(config)#exit
Console#reload