SMC Networks TigerSwitch 100 - Manual (Page 244)

C
OMMAND
L
INE
I
NTERFACE
3-100
Address Table Commands
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
mac-address-table static
Use this command to map a static address to a port in a VLAN. Use the no
form to remove an address.
Console#show interfaces switchport ethernet 1/15
Information of Eth 1/15
broadcast threshold: Enabled, 256 packets/second
Lacp status: Disabled
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Enabled
Allowed Vlan:
1(u),
Forbidden Vlan:
Console#
Command Function Mode Page
mac-address-table
static Maps a static address to a port in a VLAN GC 3-100
show
mac-address-table Displays entries in the forwarding database PE 3-102
clear
mac-address-table
dynamic Removes any learned entries from the
forwarding database PE 3-103
mac-address-table
aging-time Sets the aging time of the address table GC 3-103
show
mac-address-table
aging-time Showsthe aging time for the address table PE 3-104