SMC Networks TigerSwitch 100 - Manual (Page 289)

IGMP S
NOOPING
C
OMMANDS
3-145
ip igmp snooping query-interval
Use this command to configure the snooping query interval. Use the no
form to restore the default.
Syntax
ip igmp snooping query-interval seconds
no ip igmp snooping query-interval
seconds - The frequency at which the switch sends IGMP host-query
messages. (Range: 60-125)
Default Setting
125 seconds
Command Mode
Global Configuration
Example
The following shows how to configure the query interval to 100 seconds:
ip igmp snooping query-max-response-time
Use this command to configure the snooping report delay. Use the no
form of this command to restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries. (Range: 5-30)
Default Setting
10 seconds
Console(config)#ip igmp snooping query-interval 100
Console(config)#