SMC Networks TigerSwitch 100 - Manual (Page 211)

IP C
OMMANDS
3-67
IP Commands
An IP address may be used for management access to the switch over your
network. By default, the switch uses DHCP to assign IP settings to
VLAN 1 on the switch. If you wish to manually configure IP settings, you
need to change the switch’s user-specified defaults (IP address 0.0.0.0 and
netmask 255.0.0.0) to values that are compatible with your network. You
may also need to a establish a default gateway between the switch and
management stations that exist on another network segment.
ip address
Use this command to set the IP address for this device. Use the no form to
restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
Command Function Mode Page
ip address Sets the IP address for this device IC 3-67
ip dhcp restart Submits a BOOTP or DCHP client request PE 3-69
ip
default-gateway Defines the default gateway through which an
in-band management station can reach this
device GC 3-70
show ip interface Displays the IP settings for this device PE 3-70
show ip redirects Displays the default gateway configured for
this device
PE 3-71
ping Sends ICMP echo request packets to another
node on the network NE,
PE 3-72