SMC Networks TigerSwitch 100 - Manual (Page 226)

C
OMMAND
L
INE
I
NTERFACE
3-82
Command Usage
Communication protocols provided by devices such as terminals and
modems often require a specific parity bit setting.
Example
To specify no parity, enter this command:
speed
Use this command to set the terminal line's baud rate. This command sets
both the transmit (to terminal) and receive (from terminal) speeds. Use the
no form to restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 57600, 38400, 19200, 115200 bps)
Default Setting
9600 bps
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the
serial port. Some baud rates available on devices connected to the port
might not be supported. The system indicates if the speed you selected
is not supported.
Example
To specify 57600 bps, enter this command:
Console(config-line)#parity none
Console(config-line)#