SMC Networks TigerSwitch 100 User Manual

Page 206

OMMAND

INE

NTERFACE

3-62

Default Setting

Host Address: None
SNMP Version: 1

Command Mode

Global Configuration

Command Usage

• If you do not enter an snmp-server host command, no notifications

are sent. In order to configure the switch to send SNMP notifications,
you must enter at least one snmp-server host command. In order to
enable multiple hosts, you must issue a separate snmp-server host
command for each host.

• The snmp-server host command is used in conjunction with the

snmp-server enable traps command. Use the snmp-server enable
traps command to specify which SNMP notifications are sent globally.
For a host to receive notifications, at least one snmp-server enable
traps command and the snmp-server host command for that host
must be enabled.

• The switch can send SNMP version 1 or version 2c traps to a host IP

address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 traps.

• Some notification types cannot be controlled with the snmp-server

enable traps command. For example, some notification types are
always enabled.

Example

Related Commands

snmp-server enable traps (3-63)

Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#