SMC Networks TigerSwitch 100 - Manual (Page 178)

C
OMMAND
L
INE
I
NTERFACE
3-34
Default Setting
443
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same
port.
• If you change the HTTPS port number, clients attempting to connect
to the HTTPS server must specify the port number in the URL, in this
format:
https://device:port_number
Example
Related Commands
ip http secure-server (3-32)
ip ssh
Use this command to configure authentication control parameters for the
Secure Shell (SSH) server on this switch. Use the no form to restore the
default settings.
Syntax
ip ssh {[timeout seconds] | [authentication-retries count]}
no ip ssh {[timeout] | [authentication-retries]}
• seconds – The timeout for client response during SSH negotiation.
(Range: 1-120)
• count – The number of authentication attempts permitted after which
the interface is reset. (Range: 1-5)
Console(config)#ip http secure-port 1000
Console(config)#