SMC Networks TigerSwitch 100 - Manual (Page 157)

G
ENERAL
C
OMMANDS
3-13
Command Usage
• “super” is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
enable password command on page 3-29.)
• The “#” character is appended to the end of the prompt to indicate
that the system is in privileged access mode.
• You only need to use Level 15. Setting the password for Level 0 has no
effect.
• You cannot set a null password with the enable password command.
You will have to enter a password to access the Privileged Exec mode.
Example
Related Commands
disable (3-13)
enable password (3-29)
disable
Use this command to return to Normal Exec mode from privileged mode.
In normal access mode, you can only display basic information on the
switch's configuration or Ethernet statistics. To gain access to all
commands, you must use the privileged mode. See “Understanding
Command Modes” on page 3-6.
Default Setting
None
Command Mode
Privileged Exec
Console#enable
Console#