Line commands, Line commands -73 – SMC Networks TigerSwitch 100 User Manual
Page 217
L
INE
C
OMMANDS
3-73
Example
Related Commands
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or a virtual terminal.
Note that Telnet is considered a virtual terminal connection, and the only
commands that apply to Telnet include exec-timeout and
password-thresh.
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5
seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#
Command
Function
Mode Page
line
Identifies a specific line for configuration and
starts the line configuration mode
GC
login
Enables password checking at login
LC
password
Specifies a password on a line
LC
exec-timeout
Sets the interval that the command interpreter
waits until user input is detected
LC
password-thresh Sets the password intrusion threshold, which
limits the number of failed logon attempts
LC