Show snmp, Show snmp -65 – SMC Networks TigerSwitch 100 User Manual
Page 209
SNMP C
OMMANDS
3-65
specified by the bitmask.
• The default setting is null, which allows all IP groups SNMP access to
the switch. If one IP address is configured, the IP filtering is enabled
and only addresses in the IP group will have SNMP access.
• IP filtering does not affect management access to the switch using the
Web interface or Telnet.
Example
The following example enables SNMP IP filtering on the switch and
allows SNMP management access to client IP 10.1.2.3, and client IP group
10.1.3.0 to 10.1.3.255.
Related Commands
show snmp
Use this command to check the status of SNMP communications.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command provides information on the community access strings,
counter information for SNMP input and output protocol data units,
and whether or not SNMP logging has been enabled with the
snmp-server enable traps command.
Console(config)#snmp ip filter 10.1.2.3 255.255.255.255
Console(config)#snmp ip filter 10.1.3.0 255.255.255.0
Console(config)#