SMC Networks TigerSwitch 100 - Manual (Page 282)

C
OMMAND
L
INE
I
NTERFACE
3-138
IGMP Snooping Commands
This switch uses IGMP (Internet Group Management Protocol) to query
for any attached hosts that want to receive a specific multicast service. It
identifies the ports containing hosts requesting a service and sends data
out to those ports only. It then propagates the service request up to any
neighboring multicast switch/router to ensure that it will continue to
receive the multicast service.
Command Function Mode Page
Basic IGMP Commands
ip igmp snooping
Enables IGMP snooping GC 3-139
ip igmp snooping vlan
static Adds an interface as a member of a
multicast group GC 3-140
ip igmp snooping
version Configures the IGMP version for
snooping GC 3-141
show ip igmp snooping Shows the IGMP snooping configuration PE 3-141
show bridge multicast Shows the IGMP snooping MAC
multicast list PE 3-142
show ip igmp snooping Shows the IGMP snooping configuration PE 3-141
IGMP Querier Commands
ip igmp snooping
querier
Allows this device to act as the querier for
IGMP snooping GC 3-143
ip igmp snooping
query-count Configures the query count GC 3-144
ip igmp snooping
query-interval Configures the query interval GC 3-145
ip igmp snooping
query-max-response-tim
e Configures the report delay GC 3-145
ip igmp snooping
router-port-expire-time Configures the query timeout GC 3-147