Sun Microsystems Virtual Tape Library - Manual (Page 219)

Replication
96267 • G Appendix A VTL command line reference 205
Resume replication
iscon resumereplication -s [-u -p ]
-v [-X ]
iscon resumereplication --server-name=
[--server-username= --server-password=] --vdevid=
[--rpc-timeout=]
Description:
This command allows you to resume replication for a virtual device that was
suspended by the suspendreplication command. The replication will then be triggered
by the replication policy once it is resumed.
‐v (‐‐source‐vdevid) is the ID of the source virtual tape on the primary server to be
resumed.
‐X (‐‐rpc‐timeout) is an option to specify a number between 1 and 30000 in seconds
for the RPC timeout. The system will retry the command for the amount of time
specified if the server does not respond. The default RPC timeout is 30 seconds.
Set replication properties
iscon setreplicationproperties -s [-u -p ]
-v [-w | [-d -i <#[H|M]>]] |
[-r ] [[-t ] [-I ] [-C ]] [-c
]
[-e ] [-X ]
iscon setreplicationproperties --server-name=
[--server-username= --server-password=]
--source-vdevid=
[--watermark= | [--date= --interval=<#[H|M]>]] |
[--repl-first ] [[--replication-timeout=] [--replication-
retry-interval=] [--replication-retry-count=compression=]
[--encryption=] [--rpc-timeout=]
Description:
This command allows you to change the replication policy for the specified virtual
tape.
‐v (‐‐source‐vdevid) is required to specify the ID of the source virtual tape.
Any combination of the following two options can be used to set up a replication
trigger policy for a virtual with the tape caching property disabled.